Here we are, yet again, chasing something ignorant.
Here's my sketch:
notice the 13.600 dimension
Here's what I get after I extrude it:
Can anyone tell me why this is happening?
Can you upload the part ?
Maybe some kind of roundoff in the part template, would be nice to see the part to look at document properties instead of trying to reproduce the problem.
Was using a sketch someone else created. Dimension in sketch wasn't pointing to center of circle.
Doesn't take you long to jump off the deep end
Can you turn the part - is it getting the circles on the same plane or is it reaching down and getting the circle on the far side - I've seen it do that before.
Could it be snapping to a hidden point??
Retrieving data ...