Hello, I am new to the community and would like to ask if anyone has examples of a die cast mold with vacuum line inlets or multiple borings. I have a 30% moisture content ceramic slurry for a magnesium casting and I need to heat three upside down cone shaped impressions (shapes) filled with the ceramic slurry while drawing 6 bar vacuum (88 lbs) . I just need a resource to look at or idea on current practices to protect the ceramic infill. I guess I need to check whether the oven has the vacuum inlet on the top, bottom etc. This is a manual infill scenario only heating to 330 F. Thanks for any ideas on this.