7 Replies Latest reply on May 22, 2007 4:11 PM by Anna Wood

    surface that begins with curve and ends with straight edge

    ki ogilvie
      hey guys and gals,i'm trying to create a surface that wraps arounda cut in a cylinder then flows into a straight edge.i cut out wherethe surface is to be.the whole piece will be a duct going off fromthe cylinder. i took a screenshot to illustrate.i'm sure this is aneasy for you all.thank you for the help.
        • surface that begins with curve and ends with straight edge
          Anna Wood
          Is this a sheet metal part that you will need to flatten?

          Will the cylinder need to have a hole in it with a flanged edge?

          Or are you just attaching what you have in your sketch to the side of a cylinder.

          A bit more detail on what you are trying to accomplish will help. I can think of several ways to do what you have shown, but the modeling technique depends on your needed end result and manufacturing process.

          Regards,