AnsweredAssumed Answered

Threaded Stem Mold

Question asked by AM Eichkamp AM Eichkamp on Feb 28, 2015
Latest reply on Mar 16, 2015 by AM Eichkamp AM Eichkamp

Hi all, Ive been asked to construct a 2 impression mold around the attached picture. firstly I obviously need to model the part (also attached) says thread not needed although I might add, but can someone check this to see if its correct and I am interpreting the sketch correctly..


Afterwards ill need to create a cavity and a core for this, which seems it will need 4 sliding cores....? I am completely new to mold design after just completing some modeling classes.

The mold will be off the hasco website


so any help greatly appreciated



Greatly appreciated