1 Reply Latest reply on Feb 28, 2015 8:45 AM by J. Mather

    Threaded Stem

    AM Eichkamp AM Eichkamp

      Hi all, Ive been asked to construct a mold around the attached picture. firstly I obviously need to model the part (also attached) says thread not needed although I might add, but can someone check this to see if its correct and I am interpreting the sketch correctly..

       

      Afterwards ill need to create a cavity and a core for this, which seems it will need 4 sliding cores....? think ill make a trip over to the mold construction forum after this

       

       

      Greatly appreciarted