AnsweredAssumed Answered

Adding fastener to seed hole

Question asked by Eldon Down on May 18, 2007
Latest reply on Jun 22, 2007 by Mike Agan
Is there a practical way of knowing which hole in a multi-hole feature is the seed hole when adding a fastener/washer from toolbox? It is quite annoying to add a fastener to a hole and then go to make a feature driven pattern only to find the hole I chose was the wrong one. The feature-driven pattern is nice enough to point out the seed hole when I select the component to pattern, but at that point it's too late and then I have to go toy with mates.

Outcomes