Hallo
i'm new here
I have a problem with a simulation... i will like to simulate a banan gate being pull out of it's tool.
I have simulation with my SolidWorks.
I made the sprue, runner and banana, then i made a simpel model af the tool/cast, it plastic injection.
Then i eject the sprue, runner and banana, i will like to know witch forces there have to be applyed for the sprue, runne and banana to come out of the tool. the arrow indicante the ejecter.
Thx
where are you stuck?
this will likely be a very challenging analysis, there are a lot of locations of contact that need to be considered