8 Replies Latest reply on Feb 16, 2015 12:58 AM by VENKATESH S.

    vertical cross section of a rotated part

    Roger Ikonen

      top view.JPG

       

      When placing a vertical cross section theough the above part it works fine and I can grab the ends of the cross section line and extend it or shorten it and everything works fine.

       

      top2.JPG

       

      Now I rotate my part so my screw holes are straight and I do the same cross section view (Vertical) and again it works fine however if I grab the end of the cross section line and try to extend it or shorten it I can also rotate it around the part and it does funny things with the cross section line. Shouldn't this line stay vertical no matter what?