4 Replies Latest reply on Jun 3, 2008 3:12 AM by Leith Simpson

Display of results in Floworks

Peter Current May 10, 2007 8:53 PM

I'm pulling my hair out, every thing was fine but then on oneproject it just stopped displaying the results

The computation seem to run fine, I can see that everything isprogressing well. When the solver is finished I can't see the plotsin Solidworks. I've tried to unload and reload the results, I'veremoved Solidworks and reinstalled it, nothing seems to work.

I've pored through the tutorials and the manual is there anyknowledge data base we can look in, or anyway to pay for help?

Display of results in Floworks

David Arthur May 14, 2007 1:27 PM (in response to Peter Current)

What version of Solidworks and Floworks are you using? I have seen this happen when a collegue was using SW2007 with Floworks 2006.
Like Show 0 Likes(0)

Actions
Display of results in Floworks

1-8A3UE8 Feb 28, 2008 4:24 PM (in response to Peter Current)

Hi,
same happening to me. I use sw2007 and cosmosflo 2007. Calculation finished results good, what I expected, but cut plots sometimes sucesfully done, but you can not see plot, or during coloring plots cosmos just shuts down and I have to restart.
I un installed sw and cosmos and installed again and same happening again.
If somebody find out what is going on it would be greatly appreciated.

regards Zoran
Like Show 0 Likes(0)

Actions
Display of results in Floworks

Fernando Cuenca Feb 28, 2008 7:26 PM (in response to Peter Current)

It could be possible the assembly is blocking the plot from view. Change the transparency of the model with Results > Display > Transparency
Like Show 0 Likes(0)

Actions
- Display of results in Floworks
  
  Leith Simpson Jun 3, 2008 3:12 AM (in response to Fernando Cuenca)
  
  No that is not it I thought that to when I had a similar issue with the 2006 version. Since I upgraded to 2007 I can now see the results.
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post