AnsweredAssumed Answered

How to make table driven pattern of small bubbles on a round 2.0 dia flat disk

Question asked by Rob Rivers on Jan 21, 2015
Latest reply on Jan 22, 2015 by Rob Rivers

Hello everyone....I need help in figuring out a light disbursement “bubble” pattern, on a flat round disk.

I’ve been using solidworks since the beginning (SW-98) and never, have I had such a simple but difficult
pattern to produce. If any can share or help me with this, I would be very grateful, THANK YOU.

 

Please see attached photo and note that each "bubble" is raised approx. .005 above disk surface.

I've tried using the circular pattern, but It's not the same and I get errors once I exceed 40.

 

Appreciate the help here, thanks again.

Rob

Attachments

Outcomes