I see no reply was given to this question in almost 4-1/2 years! I have the same question and just searched through the forums and found no other info. We design 90% sheet metal parts and it is a pain to always check this box for every extruded cut we do.
Is it possible to have the "Link to Thickness" boxed checked by default for Extruded Cuts?
Thanks in advance,
Yep, John, even after all this time, its still a PITA.
It's now been 5-1/2 years and still no answer. Doesn't anyone out there know how to make "Link to Thickness" the default for sheet metal extruded cuts?
From the Knowledge Base
SPR 573014: In sheet metal, when using cut-extrude have 'link to thickness' as default. Link to thickness check box once checked should remember it for all future features by defaut.
SPR 573014: In sheet metal, when using cut-extrude have 'link to thickness' as default.
Link to thickness check box once checked should remember it for all future features by defaut.
To escalate the importance/urgency of this request, go to the KB, add your comments, and select the Yes, but notify me when this is fixed. (SPR only) option.
I followed your advise and put in some comment on this SPR. See what happens in the near future.....
Kelvin (and Chris and Yvonne and Marco), I added my comments to that SPR a while ago, and today got an automated email from SW that says this is fixed. I looked it up and it says the fix was implemented in 2014 a1. We're stil on 2013, but at least we have this to look forward to for 2014. Thanks again for that tip.
it was a pleasant surprise, that mail from SW yesterday. It takes a while but we were not forgotten. Now I have one more reason to jump from my 2010 version to the newest which by the way looks great. Last month we did some last beta testing on the 2014 version and it looks great.
Retrieving data ...