Hello SolidWorks forum,

Does anyone know if it possible to mark a 90 degree angle with "right angle symbol" (see attached image) instead of marking it with the usual degree measurement.

Hello SolidWorks forum,

Does anyone know if it possible to mark a 90 degree angle with "right angle symbol" (see attached image) instead of marking it with the usual degree measurement.

You could place the dimension, hide the extension and dimension lines (or just use text for the 90°), and then sketch in the horizontal and vertical lines. I realize that's far from ideal, but it's the best way I know.

I'm not sure what you are working on, but ASME Y14 does not support this. Features drawn at a right angle are assumed 90 deg and pick up the angular sheet tolerance.

You could place the dimension, hide the extension and dimension lines (or just use text for the 90°), and then sketch in the horizontal and vertical lines. I realize that's far from ideal, but it's the best way I know.