AnsweredAssumed Answered

Help With extrude cut

Question asked by AM Eichkamp AM Eichkamp on Jan 3, 2015
Latest reply on Jan 3, 2015 by Deepak Gupta

Hi all. Im wondering if someone can help id like to cut extrude a slot in a nut. I sketch a rectangle wider then the shaft however the cut has to be vertical to the edge oif the pollygon so the only way I could think of doing it was with the tools>modify>rotate sketch as shown in picture, below.

may question is can this be done at a revolve levl to have it lined up after the shaft is created, thanks for helping me get my head around it.

Untitledaaa.png

Outcomes