0 Replies Latest reply on Dec 19, 2014 5:33 PM by Amon Plyler

    How do I set the precision for weldment cutlist descriptions without changing the main sketch precision the structural member references?

    Amon Plyler


      Hello All,

      In my weldment drawings I need the referenced dimensions mentioned in the description to have  a precision of 1 decimal place and it currently comes up with 2 decimal places. I'm not allowed by our engineering department to change the precision of the main sketches referenced by the structural members. This makes me at the part/weldment level double-click the structural member sketch to show the dims, hold down ctrl as I select all the shown dims, and then set the precision to the correct value to 1 decimal place. This becomes tedious over multiple drawings with multiple structural members.

       

      I've tried setting units under document properties to 1 dec place, but that only works for sketches I create in the part/weldment not any sketches used to reference our standard weldment profiles.

       

      Is there a better way to set this up to minimize mouse clicks?

       

      Below are show examples of the dimensions I'd like to have show up at 1 decimal precision.

       

      Capture.PNG