Hi Folks I need to create a point on this screw, it was drawn wrong as its supposed to be a corkscrew and would need a point to pierce a cork, any help creating this and a new helix and spiral appreciated. (attached)
Do you have a drawing or image of part you are trying to reproduce?
Can't you simply Swept-Cut in the other direction?
In fact, if you had started with your cutting tool off of the end of the part (more like the real world machining operation) you would only need one Swept-Cut.
Many thanks for reply I had a problem every time I tried to select that profile sketch and path, I couldnt get it to work, I see you selected sketch 21 <16> not sure where this is?
I got a screen shot the way the screw is supposed to finish, dimensions dont need to be accurate. I have no clue how to attempt this.
I have also included the original drawing.
See if this discussion helps: Drafting a Swept Boss/Base
hei'ya AM Eichkamp,
see if this sample file is of any use to you
att-prt file is SW12
hope this helps- have a good'n kelef
Retrieving data ...