AnsweredAssumed Answered

Buggy Assembly Will Not Move in Higher Order Assembly With Motors

Question asked by Arsalan Naeem on Dec 13, 2014
Latest reply on Dec 18, 2014 by Jared Conway

Hey,

 

So end goal is to create a buggy controller in labview which controls the motors of buggy in solidworks using soft axis. The problem im having is that when i apply the motors to the wheel in a higher order assembly the buggy will not move even though the wheels spin when the motors are applied in motion study. I have added gravity and contact between all four wheels and ground. Also added a Tangent mate between the wheels and the surface. When i run the motion study the wheels move but the buggy stays stationary.

 

I have attached my files it contains my buggy and the track. Also main assembly where the buggy track and floor/

 

Thanks.

Hope you can help this is for university project.

Attachments

Outcomes