This content has been marked as final.
Show 3 replies
-
Re: Referenced geometry
Robert Hill Dec 8, 2014 2:42 PM (in response to Robert Hill)I'm sorry, I am trying to project geometry from one part in an assembly onto another to create slots for mating tabs?
-
-
Re: Referenced geometry
Glenn Schroeder Dec 8, 2014 2:42 PM (in response to Robert Hill)Edit the part in the assembly (right-click on it and choose the "Edit component" icon) and you should be able to reference the other part, assuming both parts are fully mated (at least in relation to each other).