AnsweredAssumed Answered

I want to have mesh selection between standard mesh and curvature-based mesh after mesh failure.

Question asked by Jong Lee on Dec 3, 2014
Latest reply on Dec 4, 2014 by Jared Conway

I frequently use SW models with many components with various geometries, which sometime makes it hard to achieve good meshing results due to several different contact conditions.  I noticed that I can only select standard mesh for the first time and it is inevitable to create mesh with curvature-based mesh after mesh failure. It will greatly help if standard mesh option is applicable to individual components after initial mesh attempt fails. I have tried curvature-based mesh numerous times to a minimal size but sometimes I would not reach the point to start an analysis.

Outcomes