1 Reply Latest reply on Dec 2, 2014 5:35 PM by Daniel Andersson

    3D pdf Macro

    Laurise Chedid

      I found a macro that is able to create a 3D pdf from an open part. Can I run the same macro for multiple parts? Can this be ran through our pdm vault? Or do I have to open each part seperately.

        • Re: 3D pdf Macro
          Daniel Andersson

          The macro could be edited to do batch run instead of open active document. The macro could be run with the task scheduler. Perhaps there is already a macro for 3dpdf batch runs but I  have not seen it...

           

          I pass the question about the pdm vault to the next person since I have no experience with that. Assuming that you run ePDM and not Teamcenter.....   (Rough guess that it should be possible, but no clue at all how).

           

          Just let me if you need any further guidance to edit your current macro.