2 Replies Latest reply on Dec 2, 2014 3:19 PM by Shenyu Yue

    How to limit a part in to a selected zone?

    Shenyu Yue

      Well the question is hard to understand so check the picture below.

       

      In this example

       

      The cone shall be in its slot

      1.JPG

       

      However, when I pull it up

      2.JPG

      Isolated

       

      When pull it down

      3.JPG

       

      Go into another part...

       

      So my question is how to set a limit so the part can not exceed its position?