AnsweredAssumed Answered

Problem Filleting between angled faces

Question asked by Reuben Le Prevost on Nov 25, 2014
Latest reply on Nov 25, 2014 by Reuben Le Prevost

Hi All,

New to the forum and relatively new to solidworks.

I am trying to create a fillet around the edge of a surface onto an angled face. I have attached the file. It is between the meeting point of Main-1-Surface1 and the face of Boss-Extrude3.

For this model to be sand cast it will need fillets especially in the areas between the fin and the main body where it joins the end piece.

I am unable to select both faces for a face fillet, and a constant fillet just round the main surface over (underneath the end piece).

Any help appreciated!!

Reuben

Attachments

Outcomes