im a super beginner help please u.u
Here is an example of one way to do it, see attached.
You need to do a pack and go to your assembly so it brings in the models with the assembly and then upload in here.
Your parts are missing, only the assembly file in your post. So I could only visualize it.
If I understand you correctly, you are going to mate part (1) to part (2) and I assume the holes on both parts hould fit.
I would make the holes orthogonal to face (4). Than you can mate the holes (6) concentric and the bottom of the part (2) to the face (4) on the part (1).
okok so I have to make the holes orthogonal to face and then I can mate it ??
where can I do orthogonal to face ??
here is the parts
You can always create a reference plane that is at a particular angle and then mate the part to that reference plane.
Retrieving data ...