AnsweredAssumed Answered

spur gear not configuring

Question asked by Scott Scarpinato on Nov 20, 2014

So at some point when I was modeling with spur gears in an assembly, I must have altered the toolbox file. Now, anytime I go to create a spur gear, it's stuck in one configuration except for two features (key way and hub). I've repaired solidworks using the installation disk, I've restored the file of the spur gear to it's oldest state, and frankly, I'm out of ideas.

 

Anyone know a way to fix this problem? Has anyone had this problem before? I've attached photos of the configuration manager to show you what I'm talking about.

Attachments

Outcomes