Having a problem with routing and flexible tubes.
I opened an assembly today and all my tubes were gone. All routing assemblies with tubes showed red/rebuild errors.
If I edit a route, the tube shows up in the preview. When I accept the sketch, the tube disappears again.
No amount of rebuilds, close/open, restarts fixes it.
Any ideas??
The template is a routing template.
It worked fine last time I opened it. Now its broke.
This isn't the first time this has happened. Last time I started over from scratch.
This is probably too late but if it happens again right-click on the route and select route properties. At the bottom under options make sure that "create pipes on open lines" is checked.
Brian,
If it happens again could you please provide a screenshot of the featuremanager design tree or even better, if possible and allowed, upload a pack&go of the tubing ASM?
It's been awhile since I had something similar happen and I can't recall what the cause of it was..
Have a nice one
Peter
In the routing library manager make sure that your routing template is an actual route assembly template.