AnsweredAssumed Answered

Modeling a tap

Question asked by AM Eichkamp AM Eichkamp on Nov 19, 2014
Latest reply on Nov 23, 2014 by AM Eichkamp AM Eichkamp

Evening folks. Ive tried modeling this tap and was having a problem getting the inside 16mm hole cut. I offset the the sketch by 1mm its not cutting the section out and i tried using the extruded cut but that wouldn't work either. Any ideas why that might be happening?

 

I have to then move onto the actual screw thread which I am unsure of also.

Attachments

Outcomes