I have been trying to use the edge flange tool but not getting the desired look as in the picture, can anyone show me the trick on the part attached?
That's not a developable sheetmetal part. Specifically, you're going to have problems because you would have to have intersecting bend regions in order to make it the way you're describing.
The closest you can come to creating that in SolidWorks sheetmetal is to add a tab to an edge flange-like this:
You have to leave a gap in the material between the tab and the adjacent bends, but truth is, I don't think your part is bent or formed sheet metal. I think what you have is a plate welded to a jogged piece of sheet metal.
That being the case, you should create the part as two seperate bodies and join them with a weld bead.
Retrieving data ...