After I do all the selections and get the message "would you like to start placing components", no matter my selection 2013 always crashes. Is anyone having this problem?
I am having the same issue but in 2014. I am following the tutorial, I place the first part and then the "open dialog" appears. No matter what I do from that point on it crashes.
I have recently had some luck in this area. What I did was take the parts that I was using in my from/to list and I ran them thru the routing component wizard and replaced the c-points and mate references. After that I saved them over the original version of the part. So far this has seemed to work pretty good.
Retrieving data ...