How is possible to insert the variable fillet you can see on the picture? with only two value...
thank you in advance for any response.
Instead of relying on tangent propagation make sure you manually select all three edges. Then the preview might not show up correctly but the fillet should work fine.
Sorry, for me don't work!
Here's what it looks like for me.
This is the result ... for me (SW2015!!!) I cannot set unassigned the two central control points... :-((
Changing from a radius value to unassigned doesn't always (if ever) work. You can try deselecting the edges and then selecting them again to reset the values, or you may need to start the radius over from scratch.
It works in SW2014 I don't have 2015 but I dont see why it should not work.
Another way to get around this is to convert the 3 sketch segments (line, ark, line) to spline using the fit spline command
to do this edit your sketch and control select the two lines and arc
go "tools - spline tools - fit spline" this will now convert the 3 sketch segments into a spline
Save and exit the sketch and you will now see that the highlighted face is one one face instead of 3 individual faces as they were before
Now when you do the variable fillet command you are only selecting one continuous edge to fillet instead of 3 different edges, so you now only have 2 radius's to assign
This is a problem in SW2015 and there is now an SPR for it. SR# 1-7125733483
Please add your name to the list of people finding this problem. I know they are working on a fix, but the more people that find this to be a problem the sooner the fix will be implemented.
Retrieving data ...