I have a 3" diameter part that I am trying to twist a section of .375" 2 degrees, without disturbing "twisting the entire profile" the outer and inner edges.
Message was edited by: Erik Varney
Attached is the basic model with an overall twist
Are you able to upload the model?
then I would consider doing it with two sweep features, or a revolve and then a sweep for the portion you want to twist.
I would suggest a 3 part sweep may be in order. Sweep the profile up to where you want the 2 degrees to be then do another sweep for the 2 degrees and then finish it off with the connecting sweep.
I was assuming this might be the case. Thanks I will give it a shot!
Retrieving data ...