17 Replies Latest reply on Nov 26, 2014 12:25 PM by Kelvin Lamport

    Project I'm working on looks distorted randomly.

    Cory Pickett

      When working on a project in SolidWorks, the design becomes distorted and has an exploding effect. I figured this was a graphics card issue at first so I installed updated drivers, but that did not help. I then had the graphics card replaced under warranty as I thought the card was going bad or was faulty. I still have the same issue and cannot figure out what the cause is. I've attached an image so you can see what happens. Once the image gets distorted I can get it to go back to normal by clicking a button on the mouse or scrolling up/down on the scroll wheel on my mouse. Any help would be greatly appreciated.