AnsweredAssumed Answered

How do I sketch a counter sunk hole at an angle

Question asked by Charles Peterson on Nov 6, 2014
Latest reply on Nov 6, 2014 by Jamil Snead

I am modeling a table that has a leg brace on the bottom side of the tabletop.  This brace is at a 45 degree angle to the two table top sides.  It is attached to the table top sides with screws that pass through the brace into the top via countersunk holes.

 

How do I sketch a countersunk hole that is at an angle to the surface ?

 

Thank-you in advance

 

C.Peterson

Outcomes