I have to give another bend in this rod which is down bend 17 degree after LH bend but it is creating problem in down bend. (image attached for reference )
Can any-one help me
Thanks in Advance
What kind of problem? Can you upload your part ? Have you tried sketched bend ?
Attachment is here
Have you tried sketched bend tool?
Yes I tried but It create Problem,
Following below Mess. Rcvd.
Getting same error here, please report to your VAR. I would doubt if SW sheet metal is able to handle two different bends like this, so you might have to use flex for one of the bend.
With flex command it getting bend from both the ends !
Deepak sir can you help me .
Have u any other idea
You need to set the bend planes properly to get the required bend.
I tried with Flex command but it's not form as per my requirement, bend is receiving radius .
Are you looking for sharp bend (though which is not possible practically), then you would have to model the bend.
if we keep model bend then give down bend as required then sheet-metal is unable to find-out total blanking length.
Our process is like that
blanking-u bend-lh/rh bend-down bend ( as per above attached image)
I got it with model bend !
Retrieving data ...