Under some conditions CreateLine does not put line ends to exact point I specified, instead it snaps to the intersection of body of the other feature and plane. I tried
but this prevents lines to form a contour, so FeatureCutThin2 does not work any more.
So here is my two questions:
1) Is there any way to override snapping? May be reduce strength of the snap.
2) Is there any way to form contour from lines, so FeatureCutThin2 will work?
1) Have a look at the AddToDB property for the SketchManager interface. Pay attention to the Remarks of the property. It might solve your issue.
Note that the property must be set back to False once you are done with adding stuff to the sketch...
Thanks, this works!
Retrieving data ...