My part has a 150 mm dimension, when I save to pdf, and plot, with my rule I obtain an dimension of around 145 mm. What is the problem ? How can I solve this ? Can someone help me, its very urgent .
Most likely about page scaling on printer. Can you set page scaling to none or take of "scale to fit paper" or somewhere into that direction.
It might also be a good idea to see if you have any margins set. Not sure for Solidworks, but I have seen it influence in other softwares.
but when I choose scale of pdf to 100 %, and I close my rule to the monitor , I measure 145 mm . I don´t know whats happening.
to the monitor ? Didn´t you print it out from the pdf file and measured it with a ruler on the paper ?
yes, but know i cant plot, and i try to solve this at my home, and if i choose 100 % on pdf , I probably obtain the correct dimension closing the rule at the monitor.
Have you tried to change your screen resolution and done a new measurement.....?
yes yes, thanks, I plot on my A4 plotter and now is correct . thanks for all
Retrieving data ...