2 Replies Latest reply on Oct 9, 2014 9:47 AM by Milos Stancic

    All balloons snapped to corner

    Milos Stancic

      Hi everyone,

       

      I've been having this problem for a few times now and now I have no idea what to do anymore.

       

      So, I have an assembly and created a drawing out of it. I have added balloons and everything was perfect. And once i uploaded the drawing to PLM and checked it out again to work on it, this happens. All the balloons snap to lower left corner of the sheet. You can refer attached drawing. And the first thought was, OK maybe i didn't put balloons in the locked view focus. so i deleted them all and connected them again. And everything works fine even if I rebuild it. But as soon as i close it and open it, the crazy balloons go ape sh*t straight to the left corner and on other sheets everything is normal. Has anyone faced something like this before ?!?!?!?

       

      The only thing that I can mention that maybe can have something to do with it, is that the BOM has an indented sub assy.

       

      Solidworks 2013. X 64 SP 5.0

       

       

      Thanks everyone for helping as always.