Hi I'm trying to design a duct around an cylinder, and with no sucess
I have this Profile 1
and want to "sweept " this 2 curves
to this profile 2
I would try using a loft with guide curves. You have the two profiles to use for the loft, and use the curves as guide curves. You might need to show and adjust the loft connectors if you are getting weird twisting. If that doesn't work I'd suggest attaching the file so other users can try other methods.
but I dont have the second profile designed because its a Wrap around the cylinder, any idea?
Sorry, I meant to do a surface loft, and for the first profile use the sketch at the bottom of the cylinder, and for the second profile use the edges of the hole in the cylinder. Then use Sketch16 and Sketch17 as guide curves. Does that work?
You have selected each edge segment of the hole as a separate loft profile. Instead use the selection manager to select the entire loop as a single loft profile.
When you editing the loft feature and in the area for selecting profiles, right click on one of the edges and pick SelectionManager.
Then pick the Select Closed Loop option and it should select the entire hole boundary.
Then check OK and it should enter Closed Loop <1> into the profile selection.
I did it! thank you so much!!
Retrieving data ...