2 Replies Latest reply on Oct 2, 2014 11:40 AM by Eric Irwin

    surface is open !

    New Moon

      Capture.JPG

      surface is always open even with simple line and extrude !! is it normal ?

       

      solidworks 2014 x64 sp1 - windows 8.1 x64

        • Re: surface is open !
          Deepak Gupta

          Yes this is correct behavior. Create a rectangular extrude, add surfaces on both open sides, knit all the 3 surfaces and then check.

          1 person found this helpful
            • Re: surface is open !
              Eric Irwin

              You can also select to cap the far end for a single direction extrude, which saves a feature.  If you extrude in both directions, you can cap both ends, but then for some reason it will become a solid.  I wish that it would not do that and I wish that I could cap the start end for a single direction extrude.

              1 person found this helpful