0 Replies Latest reply on Sep 25, 2014 5:23 PM by Richard Wagenaar

    drawing pop up tolerance tool

    Richard Wagenaar

      In drawing mode there is this handy tool to easily add tolerances to

      (model) dimension. This avoids the mousemovements to the property

      managers which is very usefull.

       

      However,  most dimension tolererances are added in the part model

      and this tolerance pop up tool does not work in part mode.

       

      Is there a trick to make this handy pop up tolerance tool work in part mode?

       

      The property managers are inefficient in general, it takes too much time

      and mousemovements when compared to pop up menus.

      Apart from that when you have a lot of windows open,  you first have

      to maximize to even be able to see all the options in the property managers.