4 Replies Latest reply on Sep 23, 2014 11:52 AM by Mark Kaiser

changing cofig by left mouse click sw14

Mark Kaiser Sep 23, 2014 10:10 AM

I though you used to be able to change configs of a part in an assembly by left mouse clicking on a part, in the fmt or graphics area. Am I missing something or did this get removed from sw14? Can I customize it back in?

Re: changing cofig by left mouse click sw14

Glenn Schroeder Sep 23, 2014 10:28 AM (in response to Mark Kaiser)

I get the group of icons (including the one for "Component Properties...", the old way to change configurations), along with the new drop-down for selecting configurations above it, when left- or right-clicking. The only difference is when right-clicking I also get a list of options below the group of icons. I'm pretty sure the drop-down at top was new for 2014.
Like Show 0 Likes(0)

Actions
- Re: changing cofig by left mouse click sw14
  
  Mark Kaiser Sep 23, 2014 10:46 AM (in response to Glenn Schroeder)
  
  That's the box I was missing. Found the setting:
  
  At least I wasn't totally losing my mind today.
  
  Like Show 0 Likes(0)
  
  Actions
  - Re: changing cofig by left mouse click sw14
    
    Glenn Schroeder Sep 23, 2014 11:41 AM (in response to Mark Kaiser)
    
    Did it un-check itself? Some of mine occasionally do.
    
    Like Show 0 Likes(0)
    
    Actions
    - Re: changing cofig by left mouse click sw14
      
      Mark Kaiser Sep 23, 2014 11:52 AM (in response to Glenn Schroeder)
      
      Was a fresh install on a new pc and came in unchecked. Never had this one uncheck itself.
      
      Like Show 0 Likes(0)
      
      Actions

Go to original post

Incoming Links

Re: How can I get the configuration pulldown to appear when right clicking a configured subassy in the top level assy?