I am new in sw flow simulation.And i encountered a problem...
Shortly about my project.
I have a tank of full water,with one entrance and one exit.
Supplied water flow inlet 2m3/h,temperature 90 degrees Celsijus.
Outlet conection i marked "environment pressure".
Then i run calculation.
My desire is to check the temperature of water in the output nipple after 30min.
How do I do this?
\Because,after calculation, I do not see how the time has passed...
Thanks in advance..
is this set as a transient simulation? otherwise there is no time?
if it is, do you have periodic saving enabled? if not, you won't be able to see other time steps other than in goals.
Retrieving data ...