2 Replies Latest reply on Oct 1, 2014 5:15 AM by Vipul Panchal

Assemble a floating Ball in Ball valve

Vipul Panchal Sep 23, 2014 3:27 AM

I am trying to Assemble a Ball in the Ball Valve.

While mating the Ball I want to mate the Ball in such a way that it is concentric with the orifice and also parallel with the Axis of Spindle. I was able to this. but when I mate the Valve concentric with the Orifice, the Ball does not rotate with the Spindle.

Can anybody help me...

Re: Assemble a floating Ball in Ball valve

Jamil Snead Sep 23, 2014 11:32 AM (in response to Vipul Panchal)

Instead of mating the ball concentric with the orifice, use a point or plane located at the center of the ball and mate it coincident to a plane that runs through the center of the orifice (normal to the spindle).
Like Show 0 Likes(0)

Actions
- Re: Assemble a floating Ball in Ball valve
  
  Vipul Panchal Oct 1, 2014 5:15 AM (in response to Jamil Snead)
  
  Thank you so much
  
  Like Show 0 Likes(0)
  
  Actions

Go to original post