AnsweredAssumed Answered

how to pattern a feature following a distance between two holes as reference

Question asked by Ghazi Toutounji on Sep 19, 2014
Latest reply on Sep 23, 2014 by Ghazi Toutounji

Like • Show 0 Likes0
Comment • 4

Hello,

I have a part with 6 holes equidistant but were created not by array but in the sketch itself. How can i add a feature above each hole using the holes distance as reference?

Thanks.

No one else has this question

Outcomes

4 Replies

Kelvin Lamport Sep 19, 2014 2:08 PM
Mark Correct
Correct Answer
One way is to use the Link Values tool on the spacing dimensions.
Like • Show 0 Likes0
Actions
- Pravash Sahu @ Kelvin Lamport on Sep 19, 2014 4:17 PM
  Mark Correct
  Correct Answer
  Best way is to use LINK VALUES as said by Kevin.
  Like • Show 0 Likes0
  Actions
Deepak Gupta Sep 20, 2014 1:20 AM
Mark Correct
Correct Answer
Though I'm not sure but check if sketch driven pattern can be used also.
Like • Show 1 Like1
Actions
Ghazi Toutounji Sep 23, 2014 10:14 PM
Mark Correct
Correct Answer
Thank you, all. I used Link Values for now. I will try the sketch driven pattern next.
Like • Show 0 Likes0
Actions

how to pattern a feature following a distance between two holes as reference

Outcomes

Related Content

Recommended Content