0 Replies Latest reply on Sep 18, 2014 11:16 AM by John Lhuillier

    Hole wizard placement in 2015 PR1

    John Lhuillier

      I am adding holes to a part while editing it in the context of an assembly. In 2014 when you picked the face & began placing 2d points you could snap to the center point of an existing hole to place the in context relations between the parts. In 2015 this seems to be broken. When I place the points, it will allow me to highlite the edge of the relating hole & pick the center point but fails to highlight any additional holes while the hole wizard is active. I have to place the points & then manually drag the points to get them to relate to the center point. Is this the new work flow or am I missing something.