3 Replies Latest reply on Sep 17, 2014 2:27 PM by Dave Krum

    Dimension from sketch point to plane in drawing?

    Dave Krum

      Good morning All,

      Trying to figure out how to dimension from sketch point on part to a reference plane?  I believe it can be done but I'm getting a weird error.  See the attached screenshot clip.  Basically, I need to dimension from each of the points to the base of the pipe plane.  When I go to smart dimension to pick both the bottom plane (parallel and coincident to bottom of pipe), then any sketch point, I get an error.  Can this not be done?  I need to show heights from the base (square end) of pipe to each of them for the shop to handburn (pipe too large to be sawcut with our equipment).  Thanks in advance.....