Hello all,
This is my first time posting. The problem I am having is when importing an IGES of a surface into Solidworks there is unwanted split line on the parts of the part. Therefore Ideally I would like to remove these lines to allow for a continuous surface.
I have tried the knit surface feature and the delete and fill feature but this didn't seem to work.
Many Thanks,
Adam
Adam, can you post your part here for us to take a look at? Thanks Tom
Most likely, you will not be able to remove that "edge" in your model. This looks like a Sub-D and therefore is not a true sphere (if that's what you want.) You might be better off just recreating in SW and using import for reference.
Mark
I think the only feature that will fill in an area without leaving a tangent edge is the untrim feature. You could try deleting the face and then untrim the side that it should be continuous with. It might not work but that's all I can think of.
