AnsweredAssumed Answered

Any way to reverse one chain direction in thin feature cut?

Question asked by Jeremy Grigsby on Sep 4, 2014
Latest reply on Sep 6, 2014 by Jerry Steiger

Like • Show 0 Likes0
Comment • 3

I want to cut these two sketch contours and have them in one feature. Is there a way to get it to cut the other side of just the circled one? I am doing a thin feature.

No one else has this question

Outcomes

3 Replies

Jamil Snead Sep 4, 2014 4:43 PM
Mark Correct
Correct Answer
The only thing I can think of is to join the ends of the lines so that it is one chain, and then the direction will face outside on the entire chain.
Like • Show 0 Likes0
Actions
- Jeremy Grigsby @ Jamil Snead on Sep 6, 2014 8:43 AM
  Mark Correct
  Correct Answer
  That option works. I was just wondering if there was any selection technique I was missing.
  Like • Show 0 Likes0
  Actions
  - Jerry Steiger @ Jeremy Grigsby on Sep 6, 2014 2:42 PM
    Mark Correct
    Correct Answer
    Jeremy,
    
    Did you try picking different ends on the one that you want to reverse? That's about all I can think of that might change the orientation.
    
    Jerry S.
    Like • Show 0 Likes0
    Actions

Any way to reverse one chain direction in thin feature cut?

Outcomes

Related Content

Recommended Content