I have lots of sheet metal part. I want to insert flat pattern configuration in each paert.
I think that is possible to do this with macro but no idea how to..
If any gents can help me out
Try the attached application for adding flat configurations to active sheet metal part OR batch of them.
i double click on .exe file but then after nothing happens...
Make sure SOLIDWORKS is running to either one.
For the one that says active part, make sure you've an active sheet metal part. For the other you should see a pop up window for selecting a path.
Did you tried the application with SOLIDWORKS running?
I have tried with application but i came to know that our IT department block our access to run application file.
It would be better if i can have .swp file..
Strange but they allow running SOLIDWORKS and other application.
OK, will try to make this into swp later this week.
Deepak, your batch exe works well... only thing is that it only did the first configuration. An .swp would be awesome so that I can add it to other batch macros I have, your knowledge and macros are a great resource, I appreciate your work on these.
Jason Moss unfortunately my HDD had crashed few weeks back and I had lost all the data. Will see when if I can get the swp/exe written again.
This is what I use
This helped me understand what I needed to do, thank you.
Retrieving data ...