What is the expected behavior for the measure tool when measuring between cylindrical faces? It used to default to measuring between the axes. This is what I need. What's the trick?
It is supposed to measure between the axes, but if that limit switch is an imported model it's possible that SW doesn't recognize the edge on the bottom left as an arc. Maybe it thinks it's a spline or something. Try selecting the hole cylinder, or the bottom edge of the hole.
I think you're right. I converted the edges of the hole to a sketch and SW said they were splines, not circles, so it's probably just a bad model. Thanks for the advice.
Seems alot of imported models that used to be fine on 2010 are no longer recognized as cylindrical in 2014
Retrieving data ...