AnsweredAssumed Answered

Prompt for dimention value when adding TB part??

Question asked by Evan Dlugopolski on Aug 19, 2014

Hello all,

 

Wondering if it is possible to make it so when adding a TB part, the user will receive a prompt asking them for a value to input.  This value would then be used for the diameter of a pin.  With configured TB parts you can obviously select from a list of standard sizes (see below).  I would like to find a way to make it more flexible using custom inputs in one of the two places shown below.  Anyone know of a way to do this with TB?  Or without TB for that matter...

 

 

8-19-2014 11-45-18 AM.bmp

8-19-2014 12-07-24 PM.bmp

 

Thanks!

 

Evan

Outcomes