Do anyone have an idea to convert step files into sheetmetal parts, so that I can get flat pattern. See attached
here's one approach
You have done a good job but I can't follow the steps. I can't able to delete face for holes as you did. There are some parts which has holes close to internal radius, that I can't delete face..
this one is even more funky than the first one.
what software are these coming from?
also, it might be beneficial to move this discussion over to sheetmetal category.
I think it was from SolidEdge...
I have followed your steps..It's great, thank you very much for your time.
Retrieving data ...